PUMP Vision Level Controllers

The PUMP Vision systems start with the industry's easiest to use and most feature rich level controllers. They can optionally be connected to our MOTOR Vision products for close monitoring of motor operating conditions and to SCADA Vision which provide remote monitoring and control of the entire system.

MOTOR Vision starters can be across-the-line, VFD, or RVSS. They connect to the PUMP Vision with an RS485 Modbus network and provide important motor operation data such as:

Thermal overload
Short-circuit
Ground fault
Low or high voltage
Low current (pump running dry)
Mechanical jam
Long start
Phase failure and reversal
Contactor failure
Amps per phase, average amps, and current imbalance
Volts per phase, average volts, and voltage imbalance
Frequency

The data is displayed on the PUMP Vision screen and the PUMP Vision serves the data to the SCADA Vision system.

      Tour the PUMP Vision

Information on level sensors

The PUMP Vision control provides an easy to use, intuitive user interface that gives access to:

Level control - level and set points
Pump control
Elapsed time, start counter, duration timer
Trending graph
Fault log on screen
Downloadable event log
E-mail and text message notification of alarms
Web server
MOTOR Vision server
SCADA Vision server

 

The PUMP Vision Ethernet port can be connected to the remote SCADA Vision system with the following methods:

Hard-wired CAT5e Ethernet to LAN/WAN
WiFi to wireless access point to LAN/WAN
900MHz or 2.4GHz radio Ethernet bridge to LAN/WAN
License band radio Ethernet bridge to LAN/WAN
Cellular router to Internet or VPN tunnel

Optionally, the Ethernet port can be replaced with an RS232/RS485 serial port for connection to a network such as:

Modbus
Bacnet
Lonworks